170 / 200 / 220 / 240 Watt Adjustable LED Shoebox | 26000 to 36720 Lumens | 3000K / 4000K / 5000K | 100-277V | White

Product Overview

This is an adjustable wattage LED shoebox area light designed for exterior site and area illumination. It delivers selectable output from 170 to 240 watts, supporting a lumen range of 26,000 to 36,720. Typical use includes parking lot lighting and commercial site perimeter lighting, where legacy 400W or 1000W metal halide fixtures are being replaced. The fixture is available in a white finish and supports mounting heights commonly found in parking lots, dealership lots, and roadway perimeters.

Color temperature is field adjustable between 3000K, 4000K, and 5000K. The fixture is IP65 rated for outdoor use and supports multiple mounting options, including yoke, arm, and slip fitter. It is suitable for environments requiring robust, uniform illumination and long service life.

Core Performance and Output

This shoebox light provides four selectable wattage settings: 170W, 200W, 220W, and 240W. Output ranges from 26,000 to 36,720 lumens, with a system efficacy of 153 lumens per watt. The Type 3 polycarbonate lens delivers a wide, uniform distribution suitable for area and perimeter coverage. Power factor is greater than 0.90, and total harmonic distortion is less than 15%.

Performance is optimized for mounting heights between 15 and 35 feet. At lower mounting heights, output may be excessive for small lots or pedestrian areas. Uniformity may decrease if spacing exceeds typical pole layouts for parking lots or large commercial sites.

Adjustability and Control Options

Both wattage and color temperature are field adjustable, allowing adaptation to site-specific requirements or retrofit conditions. The fixture supports 3000K, 4000K, and 5000K CCT selection via onboard controls. Wattage can be set to 170W, 200W, 220W, or 240W as needed for target light levels or energy management.

An optional photocell is available for dusk-to-dawn operation. No onboard dimming is provided. Controls are accessible during installation and can be locked to prevent tampering.

Longevity and Reliability

L70 rated life is 100,000 hours. The fixture includes 10kV surge protection for electrical reliability in outdoor environments. Operating temperature range is -40°F to 113°F, supporting year-round use in most climates.

Maintenance requirements are minimal due to the sealed IP65 housing and solid-state LED design. No lamp or ballast replacements are required during the rated life period.

Build Quality and Physical Characteristics

The housing is die-cast aluminum with a white powder coat finish. The lens is polycarbonate for impact resistance and optical clarity. The fixture measures 16 inches long, 11.8 inches wide, and 3 inches high, with a total weight of 9.1 lbs.

Mounting options include yoke, arm, or slip fitter, supporting retrofit and new installations on square or round poles. The EPA rating is 1.4, suitable for most standard pole and bracket configurations in exterior environments.

Where This Product Fits Best

This adjustable LED shoebox is designed for exterior area and site lighting where high output, uniformity, and flexible configuration are required. It is commonly installed in:

• parking lot lighting
• area lighting
• commercial site lighting
• roadway perimeter lighting
• tennis court lighting
• pickleball court lighting
• horse arena lighting
• dealership lighting

Suitable for outdoor environments exposed to weather, vehicle traffic, and public use. The IP65 rating and surge protection support reliable operation in commercial, municipal, and campus settings.

Installation and Long-Term Use

The fixture supports yoke, arm, or slip fitter mounting for compatibility with most pole types and retrofit conditions. Field adjustability for wattage and color temperature allows adaptation to site requirements without fixture replacement. The 10kV surge protector and sealed housing reduce risk of failure from electrical events or moisture ingress.

Long-term maintenance is limited to periodic cleaning of the lens and inspection of mounting hardware. No relamping or ballast service is required. The fixture is designed for straightforward installation by qualified personnel familiar with exterior pole lighting.

How This Fixture Is Commonly Used

Typical mounting heights range from 15 to 35 feet, depending on site layout and required light levels. Fixtures are spaced to achieve uniform coverage across parking lots, drive lanes, or perimeter areas. For sports courts or arenas, mounting height and aiming are adjusted to minimize glare and maximize play area visibility.

Higher wattage settings reduce fixture count but may increase glare if not properly aimed or shielded. Spacing and layout should be coordinated with site geometry and pole locations for optimal results.

Safety, Certifications, and Warranty

This fixture is UL listed and DLC Premium qualified. The housing is IP65 rated for wet locations. Surge protection is rated at 10kV. The product includes a 5-year warranty covering manufacturing defects and LED performance.

All certifications and ratings are documented for code compliance and utility rebate eligibility where applicable.

Frequently Asked Questions

Q: What is the recommended mounting height for this shoebox light?

A: Typical mounting heights are 15 to 35 feet, depending on site requirements and desired light levels.

Q: Can the wattage and color temperature be adjusted after installation?

A: Yes, both wattage and color temperature are field adjustable using onboard controls accessible during installation or maintenance.

Q: Is this fixture compatible with photocell controls?

A: An optional photocell is available for dusk-to-dawn operation. The fixture does not include onboard dimming.

Q: What is the EPA rating and how does it affect pole selection?

A: The EPA rating is 1.4. Ensure pole and mounting hardware are rated for the total EPA and weight of all fixtures installed.

Q: How should fixtures be spaced for uniform parking lot coverage?

A: Spacing depends on mounting height, wattage setting, and site geometry. Typical layouts use 2 to 4 times the mounting height for pole spacing, adjusted for uniformity and light level targets.

Application Questions and Clarification

Q: Is this fixture suitable for tennis court or pickleball court lighting?

A: Yes, the output and distribution support use on tennis courts and pickleball courts when mounted and aimed according to court lighting standards.

Q: Can this be used for dealership or campus area lighting?

A: Yes, this fixture is commonly installed for dealership lots and campus area lighting where high output and uniformity are required.

Q: Is this fixture appropriate for horse arena lighting?

A: Yes, the adjustable output and wide distribution are suitable for horse arena lighting at typical mounting heights.

Q: Does the white finish affect performance or durability?

A: The white powder coat finish is for aesthetics and does not impact optical performance or weather resistance.