20 Foot Fiberglass Flag Pole | 5.75 Inch Base Diameter | External Halyard | In Ground | Rated for 125 MPH

Product Overview

This 20-foot fiberglass flag pole is built for direct burial installation and rated for 125 mph wind exposure in unflagged condition. The pole measures 5.75 inches in diameter at ground level, tapering to 3 inches at the tip, with a total height of 23 feet including the 3-foot buried section.

The pole uses an external halyard system with #10 (5/16 inch) rope for flag raising and lowering. It ships with a 3-foot ground sleeve, 8.5-inch nylon cleat, 6-inch gold ball, 16-inch flash collar, and all fittings required for external rope operation. Total pole weight is 36 pounds.

Where This Product Fits Best

This pole is sized for sites where a 4 x 6 foot flag is appropriate and where direct burial installation is preferred over anchor base mounting. The 125 mph wind rating applies to the pole in unflagged condition, which should be factored into site selection in high-wind regions.

The fiberglass construction and white finish suit applications where a non-conductive pole material is required or preferred. Fiberglass will not conduct electricity, making it appropriate near overhead lines or in areas where electrical contact is a concern.

Performance and Functional Considerations

The 125 mph wind rating is based on unflagged conditions. When a flag is flown, wind load on the pole increases, and the effective wind tolerance decreases. In sustained high-wind environments, the flag should be lowered to protect the pole and hardware.

The external halyard design places the rope outside the pole shaft, which allows for straightforward inspection and replacement without accessing the pole interior. The nylon cleat secures the halyard at ground level.

Installation and Long-Term Use

Installation requires setting the included 3-foot ground sleeve into a concrete foundation. The sleeve has an 8-inch inside diameter to accept the pole butt. Once the sleeve is set and cured, the pole drops into the sleeve and is secured at grade level with the 16-inch flash collar.

The pole buries 3 feet below grade, leaving 20 feet of exposed height above ground. Site preparation should account for the full 23-foot total length during handling and positioning. At 36 pounds, the pole can typically be raised by a small crew without mechanical lift equipment.

How This Fixture Is Commonly Used

Once installed, the pole is operated using the external halyard and nylon cleat. The flag attaches to the halyard fittings, and the cleat locks the rope in position after raising. Lowering the flag is done by releasing the cleat and controlling the halyard by hand.

Fiberglass does not require painting or rust treatment over time. The white finish is integral to the material. Periodic inspection of the halyard, cleat, and ball hardware is typical for ongoing maintenance.

Safety, Certifications, and Warranty

This flag pole is covered by a 15-year warranty.

The fiberglass material is non-conductive, which reduces risk in environments where electrical contact is possible. The 125 mph wind rating applies only to the pole in unflagged condition.

Frequently Asked Questions

What flag size does this pole support?
The standard flag size for this pole is 4 x 6 feet.

What is the wind rating?
The pole is rated for 125 mph wind exposure in unflagged condition.

How deep does the pole bury?
The pole buries 3 feet below grade using the included ground sleeve, leaving 20 feet of height above ground.

What is the ground sleeve diameter?
The ground sleeve has an 8-inch inside diameter.

What is the warranty coverage?
This pole includes a 15-year warranty.

Application Questions and Clarification

This product description reflects the provided specifications, ratings, and configuration options. For questions related to site-specific conditions, electrical compatibility, control integration, or application requirements not addressed in the provided data, our team is available to provide clarification.